3D Spar Cap Files

[ksatter26]

Attached (I hope) are the F3D files for the Spar Caps (as transmitted to me from my 3D printer buddy).

You will probably want to modify the half spar (rear) cap by removing about a half an inch of the circumferential flange to make a better fit against the AN5 mounting bolt.

I used pop rivets to provide tabs secure the caps, but you may want to modify the design to have the printer add these tabs.

SpartCap v3.f3d

(85.01 KiB) Downloaded 91 times

Spar Tube Adapter - Parametrized v2.f3d

(69.9 KiB) Downloaded 102 times

Spar Tube Adapter - Parametrized v2.skp

(190.6 KiB) Downloaded 78 times

[Badland-F5 Pilot]

Attached (I hope) are the F3D files for the Spar Caps (as transmitted to me from my 3D printer buddy).

You will probably want to modify the half spar (rear) cap by removing about a half an inch of the circumferential flange to make a better fit against the AN5 mounting bolt.

I used pop rivets to provide tabs secure the caps, but you may want to modify the design to have the printer add these tabs.


FullSparCap.JPG


HalfCapMod.JPG


SpartCap v3.f3d


Spar Tube Adapter - Parametrized v2.f3d


Spar Tube Adapter - Parametrized v2.skp

Thanks Kurt. I'll spin up the printer and see what happens.

Todd